How To Use Pitcher Mould

A pitcher mould is a type of mould used for making ceramic pitchers. Here are the general steps for using a pitcher mould:

Prepare the clay: Knead the clay until it's soft and free of air bubbles.

Apply a release agent: To prevent the clay from sticking to the mould, apply a release agent such as silicone spray or a mixture of water and soap to the inside of the mould.

Press the clay into the mould: Press the clay into the mould, starting at the bottom and working your way up. Use your fingers or a wooden tool to press the clay firmly into the mould, making sure it reaches all the crevices and details.

Trim excess clay: Use a sharp tool to trim off any excess clay around the edges of the mould.

Remove the pitcher from the mould: Gently tap the mould to loosen the clay, then carefully remove the pitcher from the mould.

Clean up: Use a sponge or damp cloth to smooth out any rough edges or seams on the pitcher.

Let the pitcher dry: Allow the pitcher to dry slowly, preferably under plastic or in a damp box to prevent cracking.

Fire the pitcher: Once the pitcher is completely dry, fire it in a kiln according to the manufacturer's instructions.

Keep in mind that these steps are general and may vary depending on the specific pitcher mould and clay you are using. Always refer to the manufacturer's instructions for the best results.